BRP Evinrude Specifications download pdf (Page 48)

OUTBOARD INSTALLATION

STEERING SYSTEMS

Attach chain to lift eye on back of engine block.

Carefully lift engine with hoist.

To avoid damage to the outboard,

lift the outboard in one smooth motion. DO

NOT allow the outboard to bounce.

STEERING SYSTEMS

Mechanical Cables

All Evinrude outboards equipped with tilt tubes are

compatible with mechanical steering systems that

meet ABYC Standard P-17. Single-cable mechan-

ical steering systems can be used on single or

dual-outboard installations if an ABYC-approved

steering link is used.

Dual-cable mechanical steering helps provide firm

steering control at high speeds.

Extend the steering cable and lubricate the inner

core before installation.

IMPORTANT: Install steering cable through tilt

tube before mounting outboard on transom.

Tighten nut securely.

WARNING

If the chain snap hooks are too large, the

cast in lift eye could break causing the out-

board to drop suddenly causing personal

injury and damaging the outboard.

1. Lift eye 007212

007213

NOTICE

ABYC-approved mechanical steering cable. 5873

WARNING

DO NOT use cable over pulley steering on

40 HP and larger outboards.

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 101 102

No comments

BRP Evinrude Specifications Page 48