BRP Evinrude Specifications download pdf (Page 73)

OUTBOARD RIGGING

EVINRUDE E-TEC MODELS 15–30 HP

EVINRUDE E-TEC

MODELS 15–30 HP

Cable, Hose, and Wire Routing

Refer to Control Cable Identification on p. 51.

Remove cable entry grommet cover and grommet.

Remove rubber membrane from grommet holes

as needed.

Install cables and wiring harness(es) through

grommet as shown:

When grommet is in place and all cables have

been installed, tighten a tie strap around the out-

side of the grommet to form a watertight seal

around the cables.

Place blank sealing decal on lip of lower motor

cover at each harness connector tie strap to pre-

vent water intrusion.

After installation, make sure there

is enough clearance for all cables to avoid

binding or chafing through all engine steering

and tilting angles.

Control Cable Installation

Refer to Control Cable Identification on p. 51.

Make sure the remote control is in NEUTRAL, and

throttle is in the IDLE position.

Removal of lower motor covers is NOT required.

Some images show lower covers removed for

clear illustration.

Place the shift cable on the shift lever pin.

Hold the shift linkage in NEUTRAL.

Push and pull on the shift cable and observe the

cable slack. Hold the casing guide in the center of

the slack.

CAUTION

To prevent accidental starting while servic-

ing, disconnect the battery cables at the

battery. Twist and remove all spark plug

leads.

1. Cable entry grommet cover 007120

1. Throttle cable

2. Shift cable

3. Electrical harness

007129

1. Tie strap

2. Blank sealing decal

007127

NOTICE

1 2 ... 68 69 70 71 72 73 74 75 76 77 78 ... 101 102

Comments to this Manuals

No comments

BRP Evinrude Specifications Page 73

Comments to this Manuals

Related products and manuals for Engine BRP Evinrude