BRP Evinrude Specifications download pdf (Page 55)

OUTBOARD RIGGING

EVINRUDE E-TEC 90° V MODELS 200–300 HP

same path to the starboard side of the powerhead.

Secure all cables with clamps.

After installation, make sure there

is enough clearance for all cables to avoid

binding or chafing through all engine steering

and tilting angles.

Control Cable Installation

Refer to Control Cable Identification on p. 51.

Remove control cable trunnion covers and cable

attachment hardware.

Shift Cable Installation and Adjustment

Place the shift cable on the shift lever pin and

install the washer and retainer clip. Refer to Cable

Retainer Clip Installation on p. 51.

IMPORTANT: Do not bend or deform clip.

Make sure the remote control, gearcase, shift link-

age, and shift cable are in NEUTRAL.

Hold the shift linkage in NEUTRAL.

Push and pull on the shift cable and observe the

cable slack. Hold the casing guide in the center of

the slack.

Adjust shift cable trunnion to align with center of

the trunnion block. Place cable trunnion in trun-

nion block.

Install trunnion cover and screw. Tighten screw to

a torque of 60 to 80 in. lbs. (7 to 9 N·m).

Throttle Cable Installation and Adjustment

With remote control lever in NEUTRAL, pull firmly

on throttle cable casing to remove slack.

Place throttle cable on throttle lever pin and install

washer and retainer clip. Refer to Cable Retainer

Clip Installation on p. 51.

003974

1. Trunnion covers 005037

NOTICE

1. Shift cable retainer clip and washer

2. Shift cable trunnion

005038

1. Throttle cable retainer clip and washer 003967

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 101 102

No comments

BRP Evinrude Specifications Page 55